Educational Journey
Jawaharlal Nehru Technological University Hyderabad College of Engineering
Ph.D in Mechanical Engineering • Mechanical Engineering
2022Experience
Assistant Professor(Sr)
2024 - Present • Mechanical EngineeringAssistant Professor
2017 - 2023 • Faculty of Science and TechnologyICFAI Tech Schools
0 - 0Affiliations
International Association of Engineers
Life Member
Member since 0Institution of Engineers (India)
Life Member
Member since 0Indian Society for Technical Education
Life Member
Member since 0Research
Construction of Concrete Wall with Resistance to Explosions- Aview
The research was to give the people a great protect against the explosions by using Fiber – reinforced concrete. The Fiber – reinforced concrete is very difficult to be used in the actual Construction as the Fiber can’t be mixed up with the ready mixed concrete system. The Fiber has a high resistance against the blasts and also needed a huge load of fiber. The required amount of fiber can result in reduced in practicable and lacking quantity of fiber. It’s been very tough to put fiber – reinforced concrete on site Placing with ready mixed concrete system plant for mixing and placing. Thus, it has analysed properties of Steel and polymeric fiber to increase practicable and shaking in mixer. The beginning experimental test mixing fiber reinforced concrete has been tested in the actual field Construction of chemical plant. As the result from the test, it is expected to present to the combined fiber for required mechanical performance with unfavourable effect on practicable of the Mixture.
Transient Thermal Analysis of the Turbine Blade
Turbine blade is the individual component which makes up the turbine section of a gas turbine or steam turbine. The blades are extracting power from the high temperature, high pressure gas makes by the combustor. The turbine blades are often the limiting component of gas turbines. In general, all solid and non-solid models will deform when certain amount of thermal or structural loads applied within the environmental condition. With specific end goal to discover the progressions of the item or segment analysis software is utilized. In this paper the model is designed concerning all the accessible constraints utilizing like Catia in which all the individual parts are created in part module and assemble each other in assemble module. Later the product record is changed over to "stp" file format (standard exchange of product file) and imported to Ansys workbench to find deformation and analytic value with respect to the model or product definitions. Ansys software finds the precise or estimated solutions.
