- Home
-
Board
- Editorial Board
- Apply For Reviewer
-
Research Publishing Standards
- Guidelines
- Peer Review Policy
- Short Guide to New Editors
- Retraction Guidelines
- Research Institute
- Recommendations for the Board of Directors
- Editor Research Audit and Service Assessments
- Guidelines for Journals Publishers
- Code of Conduct for Journal Publishers
- Commandment in Social Media
- Suggestions
- Authorship Disputes
- Rights and Responsibilities
- Editors Home
- Visibility
- Information
- Apply for Editorial
- About
- Call for Paper
- Research Community
-
Journals
- Computer Science
-
Medical Research
- A: Neurology & Nervous System
- B: Pharma, Drug Discovery, Toxicology & Medicine
- C: Microbiology & Pathology
- D: Radiology, Diagnostic Imaging and Instrumentation
- E: Gynecology & Obstetrics
- F: Diseasescancer, ophthalmology & pediatric
- G: Veterinary Science & Veterinary Medicine
- H: Orthopedic & Musculoskeletal System
- I: Surgeries & Cardiovascular System
- J: Dentistry & Otolaryngology
- K: Interdisciplinary
- L:Nutrition and Food Science
- Engineering
- Science Frontier Research
- Management
-
Human-Social Science
- A: Arts & Humanities psychology, public administration, library sciences, sports, arts, media, music
- B: Geography, Environmental Science & Disaster Management
- C: Sociology & Culture
- D: History, Archaeology & Anthropology
- E: Economics
- F: Political Science
- G: Linguistics & Education
- H: Interdisciplinary
-
Fellow
-
Support
Account
×
Finite Element Simulation of the Reverse Bending and Straightening of Steel Bars Used for Civil Engineering Applications
Steel bars used for pre-stressing concrete and as tensile armour wires are routinely subjected to reverse bending and straightening test to detect laminations in the bars. In this paper, three dimensional FE simulation of the reverse bending and straightening of steel wires over rotating rollers conducted as a part of the research to numerically investigate the effects of the combination of reverse bending and laminations on the tensile properties of bars for civil engineering applications is presented. The appropriateness of the simulation procedure employed in this work is demonstrated by a good agreement between the finite element and experimental results.
