- Home
-
Board
- Editorial Board
- Apply For Reviewer
-
Research Publishing Standards
- Guidelines
- Peer Review Policy
- Short Guide to New Editors
- Retraction Guidelines
- Research Institute
- Recommendations for the Board of Directors
- Editor Research Audit and Service Assessments
- Guidelines for Journals Publishers
- Code of Conduct for Journal Publishers
- Commandment in Social Media
- Suggestions
- Authorship Disputes
- Rights and Responsibilities
- Editors Home
- Visibility
- Information
- Apply for Editorial
- About
- Call for Paper
- Research Community
-
Journals
- Computer Science
-
Medical Research
- A: Neurology & Nervous System
- B: Pharma, Drug Discovery, Toxicology & Medicine
- C: Microbiology & Pathology
- D: Radiology, Diagnostic Imaging and Instrumentation
- E: Gynecology & Obstetrics
- F: Diseasescancer, ophthalmology & pediatric
- G: Veterinary Science & Veterinary Medicine
- H: Orthopedic & Musculoskeletal System
- I: Surgeries & Cardiovascular System
- J: Dentistry & Otolaryngology
- K: Interdisciplinary
- L:Nutrition and Food Science
- Engineering
- Science Frontier Research
- Management
-
Human-Social Science
- A: Arts & Humanities psychology, public administration, library sciences, sports, arts, media, music
- B: Geography, Environmental Science & Disaster Management
- C: Sociology & Culture
- D: History, Archaeology & Anthropology
- E: Economics
- F: Political Science
- G: Linguistics & Education
- H: Interdisciplinary
-
Fellow
-
Support
Account
×
Optical, Structural and Morphological Studies of Chemical Bath Deposited Antimony Sulphide Thin Film
Thin films of antimony sulphide were successfully deposited on glass substrates by chemical bath deposition technique. Morphological studies and structural analysis were performed by scanning electron microscopy (SEM) and x-ray diffraction (XRD) respectively. Optical characterization was done using an AVASPEC-2048 UV-VIS-NIR spectrophoto- meter in the wavelength range of 200-900nm. Optical studies reveal a direct band gap of about 1.6eV. The thickness of the film was calculated from surface profile analysis and estimated at about 0.7μm.
