F: Electrical & Electronic

F: Electrical & Electronic (302)

GJRE: F

Proto-type Silicon Drift Detectors (SDDs) have been realized through a pilot stage fabrication run at the Micro-fabrication facility at Indian Institute of Technology - Bombay (IIT-B). Taking precedence from the fabrication run at IIT-B, commercial grade SDDs with on-chip low noise JFETs are being developed for low energy X-ray spectroscopy and position sensing applications using silicon...
Paper Information
Authors Dr. Pourus Mehta , Sudheer K.M, V.D. Srivastava, Rejeena Rani, V.B Chandratre, Y.P. Prabhakara Rao, C.K. Pithawa
Read Journal Click Here
Read Paper Click Here
Page No. 23 to 33

Nowadays, Wheeled Mobile Robots (WMRs) are built and the control system that used to control them are made by Electronic Engineers. Depend on their desire design of WMR, Technicians made used of Microcontrollers as controlling machines and DC Motors for motion control. Autonomous robotic vehicle guidance for indoor navigation has been developed for Mobile Industrial Robot model. The resu...
Paper Information
Authors Dr. Chigulla Leela Kumari
Read Journal Click Here
Read Paper Click Here
Page No. 11 to 14

In this paper a high speed, low power 12-bit, analog-to-digital converter in CMOS 0.13 micron technology that makes it suitable for UWB is designed and implemented. For designing the particular ADC a bottom up hierarchical method is adopted. First according to the specification, the design of aspect ratio of the transistors used in our design is done. There were many challenges throughou...
Paper Information
Authors Mr. Appa Rao M., Dr. Ramana Reddy P., Cyril Prasanna Raj P.
Read Journal Click Here
Read Paper Click Here
Page No. 15 to 21

Energy performs a cardinal role in strategies of preferment for the developing countries. Traditional energy source reliance is a prima challenge for ameliorating the performance of their energy suppliers to benefit energy consumers. Hydrocarbons are already used a great deal as an energy source and they also harshly criticized because oil and gas are expensive. Consequently some develop...
Paper Information
Authors Dr. Khizir Mahmud, Sayidul Morsalin, Md. Shamsul Alam
Read Journal Click Here
Read Paper Click Here
Page No. 15 to 20

South Asian region is enjoying unprecedented booming economic growth. But this booming pecuniary emergence is becoming stifled by significant shortages in energy supply. If the exigent corrective steps are not initiated and implemented, it may be arduous to sustain the achieved growth rates and overall sustainable development. The region’s political leaders and its busin...
Paper Information
Authors Dr. Khizir Mahmud
Read Journal Click Here
Read Paper Click Here
Page No. 15 to 20

In this work the design and implementation of Automatic Microcontroller-Based Controlling of Single Phase Power Factor using Capacitor Banks with Load Monitoring is performed in correspondence with the attached load to the system. The system will continuously monitors the load and how much lead or lag occurred in power factor, its type and behavior of the load enduring at that time and w...
Paper Information
Authors M. Naeem Afridi
Read Journal Click Here
Read Paper Click Here
Page No. 1 to 8

A simple design to compute accurate resonant frequencies of circular microstrip antennas using artificial neural networks. (ANN) is proposed. ANN model is developed to calculate the antenna dimensions for the given resonant frequency, dielectric constant and height of substrate. ANN is designed using radial basis function networks. The results show better agreement with the trained and t...
Paper Information
Authors Dr. Sami Bedra
Read Journal Click Here
Read Paper Click Here
Page No. 9 to 14

Two printed wide-slot antennas with E-shaped patches and slots, for broadband applications, are proposed. They are fed by a coplanar waveguide (CPW) and a microstrip line with almost the same performances. Detailed simulation and experimental investigations are conducted to understand their behavior and optimize for broadband operation. Good agreement between the measurement and simulati...
Paper Information
Authors Dr. Kapil Goswami
Read Journal Click Here
Read Paper Click Here
Page No. 43 to 47

Reliability is concerned with the system capability of survival. In the past forty years, customer expectations have been increasing in response to evolving new technologies. As part of these evolutions, they are demanding from their suppliers: products with higher quality, low initial cost, improved customer support and products that are easy and inexpensive to maintain. For a supplier ...
Paper Information
Authors Dr. Tanay Lakshman
Read Journal Click Here
Read Paper Click Here
Page No. 37 to 42

The polytechnic as of today is not aware of energy efficiency and management measures but has the capability of at least saving 230.1 gallons of diesel per day. In other to further increase conservation capacity considering the economic and environmental benefits, this paper contains verifiable data to show that energy consumption capacity can be reduced by 70 percent if conservation mea...
Paper Information
Authors Dr. E.I. Igweonu, B.J. Robert, C. V. Eguzo
Read Journal Click Here
Read Paper Click Here
Page No. 214 to 24