F: Electrical & Electronic

F: Electrical & Electronic (302)

GJRE: F

This paper presents speed control of a separately excited DC motor using fuzzy logic control (FLC) based on MATLAB Simulation program. This method of speed control of a dc motor represents an ideal application for introducing the concepts of fuzzy logic. The paper shows how a commercially available fuzzy logic development kit can be applied to the theoretical development of a fuzzy contr...
Paper Information
Authors Ravinder Kumar, Vineet Girdhar
Read Journal Click Here
Read Paper Click Here
Page No. 1 to 6

This paper deals with the implementation of a new low cost five level inverter which converts the 9V DC to 9V AC. Complexity and cost of the system are reduced as compared to other configurations by using only five switches, eight diodes and two capacitors. In the proposed scheme, control circuit is designed using 89C51 microcontroller to produce sinusoidal pulse width modulation(SPWM).T...
Paper Information
Authors Neelashetty Kashappa, Ramesh Reddy K
Read Journal Click Here
Read Paper Click Here
Page No. 25 to 28

The performance of Erbium Doped Fiber Amplifier (EDFA) depends on various parameters like, Er+3 doping concentration, active fiber length, pump power, pumping wavelength etc. In this paper, the analysis of gain and noise figure (NF) of EDFA is done at different pump power (10, 50, & 100mw) and at different fiber length (10, 30, & 50m) for different pumping configuration i.e. forward pump...
Paper Information
Authors Ms. Prachi Shukla, Asst. Prof. Kanwar Preet Kaur
Read Journal Click Here
Read Paper Click Here
Page No. 19 to 23

In this paper a closed loop PI controller is designed to obtain the desired output torque, speed and stator phase current of interior permanent magnet synchronous motor (IPMSM) fed by a three-level diode clamped inverter which is built using twelve IGBTs (Insulated-gate Bipolar Transistor). Model of IPMSM is established using the equations describing dynamic behavior of interior permanen...
Paper Information
Authors G. Sree Lakshmi, S. Kamakshaiah, G. Tulasi Ram Das
Read Journal Click Here
Read Paper Click Here
Page No. 9 to 17

This paper presents a novel distribution power flow algorithm to estimate losses and analyze unbalanced distribution systems. An unbalanced distribution network is decomposed into clusters. The unbalanced laterals are solved using the backward/forward sweep method in each phase. The clustering of total network makes faster computation. The three phase modeling of all the distribution tra...
Paper Information
Authors T. Murali Krishna, N.V. Ramana, S. Kamakshaiah
Read Journal Click Here
Read Paper Click Here
Page No. 1 to 8

The general principles of several types of receivers fall under the two main headings of TRF (tuned radiofrequency) receivers, where the received signal is processed at the incoming frequency right up to the detector stage, and the superhet (supersonic heterodyne) receiver, where the incoming signal is translated (sometimes after some amplification at the incoming frequency) to an interm...
Paper Information
Authors Solomon Lule Workneh, Dr. M V Raghavendra, Dr. Vuda Sreenivasarao, Dr. Babu PGReddy
Read Journal Click Here
Read Paper Click Here
Page No. 19 to 23

The first problem in our third millennium is energy. For this raison, we try to find a new solution to develop different ways of distribution and energy use. This article presents the design of a sliding mode controller using sliding mode observation technique which aims to simplify the control procedure. For ameliorating the quality of the energy transferred from the power supply to the...
Paper Information
Authors ALI Djerioui, K. Aliouane, F.Bouchafaa
Read Journal Click Here
Read Paper Click Here
Page No. 13 to 17

This paper analyzes the dependency of power output of the building integrated photovoltaic application in Bangladesh on various tilt and azimuth angle. Again this paper shows the temperature dependency of the output power of the building integrated photovoltaic application in Bangladesh. From the analysis, it is seen that if tilt angle is decremented from 90 deg to 1 deg, the power of pr...
Paper Information
Authors Md. Hafizur Rahman, Jinia Afrin
Read Journal Click Here
Read Paper Click Here
Page No. 9 to 12

The traditional platforms for implementing hearing aid algorithms have been application specific integrated circuits (ASIC) and some general purpose DSP chips. One of the most important issues involved in hearing aid design is power consumption, i.e., battery life. This paper introduces an alternative method for implementing hearing aid algorithms by using truncated-matrix multipliers. T...
Paper Information
Authors Thomas L. Hemminger, E. George Walters
Read Journal Click Here
Read Paper Click Here
Page No. 1 to 7

In recent years, Power engineers are increasingly concerned over the quality of the electrical power. In modern power system consists of wide range of electrical, electronic and power electronic equipment in commercial and industrial applications. Since most of the electronic equipments are nonlinear in nature these will induce harmonics in the system, which affect the sensitive loads to...
Paper Information
Authors B. Gopal, Pannala. Krishna Murthy, G.N. Sreenivas
Read Journal Click Here
Read Paper Click Here
Page No. 49 to 57